Changing The Collet Chuck; Fitting The Rip Fence; Setting Up; Switching On And Off - Parkside POF 1200 D3 Traducción Del Manual De Instrucciones Original

Changing the collet chuck

NOTE
► All of the cutters in the supplied cutter set are
equipped with an 8 mm shank .
Use the pre-assembled collet chuck
with them . When using milling cutters with a
6 mm shank, replace the collet chuck as
described below .
♦ Press the spindle locking button
down .
♦ Undo the union nut anticlockwise with the
open-ended spanner
(8 mm) can be removed .
♦ Fit the collet chuck
ATTENTION! Do not tighten the union nut
with the open-ended spanner
tool is fitted . Otherwise, the collet chuck may be
damaged .
♦ Release the spindle locking button

Fitting the rip fence

♦ Undo the wing screws
♦ Push the sliding rods
openings next to the wing screws . Retighten the
wing screws for the sliding rods .

Setting up

Switching on and off

Switching on
♦ Press the safety lock-out
♦ Press the ON/OFF switch
machine is running, you can release the safety
lock-out .
Switching off
♦ Release the ON/OFF switch
POF 1200 D3
(8 mm)
and hold it
until the collet chuck
(6 mm) .
unless a milling
.
for the sliding rods .
into the corresponding
and hold it down .
. Once the
.

Preselecting the rotation speed

♦ Set the required speed using the adjusting
wheel for speed preselection
1–2 = low speed
3–4 = average speed
5–7 = high speed

Setting the milling depth

♦ Make sure that the clamping lever
If it is released, turn it anticlockwise until it is
locked .
♦ Place the appliance onto the workpiece .
♦ Rotate the step stop
lowest position (0 mm) .
The depth stop is now in line with the lowest
position (0 mm) .
♦ Undo the locking screw
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the milling machine is touching the
surface of the workpiece .
♦ Lock the clamping lever
clockwise .
♦ Slide the depth stop
reaches the lowest position (0 mm) of the step
stop .
♦ Set the depth stop
depth, tighten the locking screw
NOTE
► The values shown on the milling depth adjust-
ment scale do not correspond to the
actual milling depth . It should always be set
relative to a selected point on the milling
depth adjustment scale
♦ Now, release the clamping lever
the appliance again .
♦ Check the milling depth by means of a practical
test .
.
is locked .
until it engages in the
.
by turning it
by turning it anti-
downwards until it
to the desired milling
.
.
and raise
GB │ MT │ 49 ■