Grabo NEMO Manual Del Usuario página 15

irritation or burns.
e) Do not use a battery or tool that
is damaged or modified. Damaged
or modified batteries may exhibit
unpredictable behaviour resulting in fire,
explosion or risk of injury.
f) Do not expose a battery or tool to fire or
excessive temperature. Exposure to fire
or temperature above 130 °C/265 °F may
cause an explosion.
g) Follow all charging instructions and do
not charge the battery or tool outside
the temperature range specified in the
instructions. Charging improperly or at
VACUUM LIFTING DEVICE SAFETY WARNINGS
a) Do not deliberately try to rip the load
off with extreme force. There is a risk
of the load crushing feet and hands and
damaging the object and tool.
b) Do not lift objects weighing more than
170 kg (375 lbs). There is a risk that the
weight could fall off.
c) Risk of load crushing feet and hands and
damaging the object and tool. Do not
shake the tool while lifting, moving and
placing objects. Do not swing or shake
the load while lifting, moving and placing
objects. Do not use the tool when the
seal is worn out. Lift and carry the load
with uniform speed without sudden sharp
and strong movements.
d) Do not use the tool while the battery
charge is low. There is a risk of injury and
damage to the materials being lifted.
e) If the sealing force begins to noticeably
decrease while the battery is fully
charged, check the rubber foam seal for
wear and tear or damage. Do not attempt
to lift anything with the tool until you
have replaced the seal.
f) Use caution when lifting large thin
flexible sheets, like drywall, cardboard,
plastic, plywood, thin sheet metal
NEMO GRABO | Operator's manual
temperatures outside the specified range
may damage the battery and increase the
risk of fire.
6) SERVICE
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
b) Never service a damaged battery. Service
of battery should only be performed by
the manufacturer or authorized service
providers.
etc. Thin sheets bend and flex and can
unexpectedly change curvature above
limit and detach.
g) Do not attach the tool to surfaces
with visible puddles of water. Internal
components are not waterproof. If
water is sucked into the air ducts it can
cause permanent damage to the tool.
The Nemo GRABO® is not waterproof
and therefore extreme caution should
be taken when using it in the rain or wet
conditions.
h) Do not drop the tool from heights above
1.5 meter above the ground (chest level).
If dropped by accident, inspect the seal
side lips for damage.
i) Do not place heavy objects on top of the
tool.
j) To avoid overheating, do not cover the
tool.
k) Ensure the switch is in the off-position
before transporting the tool and when
in storage. Be mindful that the tool is not
switched on accidently.
! WARNING! Weight may drop without
warning if the safety precautions are
not kept! The Nemo GRABO® creates a
strong vacuum. In case the seal is broken
15