Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFEGUARDS
Read all instructions before using.
Important information is highlighted by these terms:
WARNING–
Important safety information for hazards that might
cause serious injury.
CAUTION–
Information for preventing damage to the product.
NOTE–
Information to which you should pay special attention.
READ ALL INSTRUCTIONS BEFORE USING.
!
Please read carefully before use. Failure to comply may result in severe injury.
!
Do not exceed the 300 lb. maximum weight capacity of this safety frame.
!
Evenly distribute weight between the armrests during use.
Ensure all detent buttons are properly engaged in position prior to use.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT
IN SERIOUS INJURIES.
SAVE THESE INSTRUCTIONS.
1
WARNING
WARNING
WARNING
ASSEMBLY INSTRUCTIONS
Before beginning assembly, identify all parts.
1. Remove existing toilet seat / lid assembly.
2. Place toilet safety frame bracket between toilet
fixture and toilet seat / lid assembly with rounded
part of bracket facing back of toilet (Figure 1).
3. Replace toilet seat / lid and reinsert mounting
bolts through bracket and toilet fixture.
Replace and tighten nuts.
4. Insert side frames into bracket. Depress detent
button and slide side frame into desired position
(Figure 2).
5. Adjust footpieces to desired height. Make sure
both footpieces are fully engaged and adjusted
at equal heights.
6. Make sure mounting hardware is tightened and
all detent buttons are fully engaged before use.
CLEANING
Your safety frame can be easily cleaned with regular
household cleaning products. DO NOT use abrasive
powders or scouring pads.
Grip Cleaning Instructions
Clean the grips with a mild soap, detergent or
household cleaner. Do not use an organic solvent
(such as acetone, MEK, lacquer thinner, lighter fluid,
dry cleaning fluid, gasoline or turpentine) that may
dissolve the plastic and cause the grip to loosen.
*Tips on This Product Contain
Dry Natural Rubber.
G30300-1 (PIC-00373)
G30300-1 (PIC-00373)
Revised: 06/21/18
Revised: 06/21/18
Figure 1
Figure 2
2
Publicidad
