Publicidad
Idiomas disponibles
Idiomas disponibles
Check to see if the faceframe protrudes above the floor of the cabinet, then subtract any
protrusion and the desired door/frame reveal from 1-1/2˝ to get the location of the bottom of
the door relative to the bottom of the face of the shelf. Recheck the Shelves to make sure
the grooves in the Bearing Hub are engaging the Bearing pins and that they are pushed onto
the pins as far as they will go. Mark and drill 1/8˝ pilot holes, 1/4˝ deep using the existing
holes in the Bottom Shelf face as a template. Fasten the Bottom Shelf to door using (4) #10 x
1˝ Screws (F).
Step 7 Making sure the Top Shelf is pushed down onto the top Bearing pin as far as it will go, mark
and drill 1/8˝ pilot holes, 1/4˝ deep using the existing holes in the Top Shelf face as a
template. Fasten the Top Shelf to door using (4) #10 x 1˝ Screws (F).
Step 8 Use installation template to mark and drill 1/16˝ pilot holes in the bottom and top of cabinet
interior.
Step 9 Place Bottom mounting bracket (D) over drilled holes and fasten using (2) #8 x 1/2˝ Screws
(G). Install the Clutch Mount Assembly (E) in the same manner using 2 Screws (G).
Step 10 Using the lower post as a handle to keep shelves from sliding off Bearing pins, and making
sure that the upper post is inserted fully into the lower post, place the entire door-mounted
unit into the cabinet. Engage the bottom of the post raising assembly with the bottom
mounting bracket. Loosen the setscrew that holds the Upper post in the lower post and slide
up the upper post to engage the clutch mount assembly. Push the upper post into the clutch
mount assembly as far as it will go, then back out 3/32˝ to leave room for rotational
adjustment. Tighten the set screw securely with a screwdriver.
Step 11 If cabinet door needs to be raised or lowered to center in the cabinet opening, loosen height
adjusting screw 1 turn (leaving screwdriver engaged in screw). Using the screwdriver as a
handle, rotate as needed to set the door to the proper height and tighten screw securely. If
the Upper post won't move far enough, the screw on the clamp of the Clutch Mount
Assembly can be loosened and the Upper post moved up or down 1/8˝ more.
Step 12 Loosen clamp screw on the Clutch Mount Assembly 1 turn. Gently turn the shelves
clockwise (push with left hand). When the shelves stop turning easily, return the shelves
back turning counterclockwise (push with right hand). Stop turning at the moment the door
is perfectly aligned in the opening. Turn the doors back into the cabinet clockwise (push
with left hand). Stop turning when you can easily reach the clamp screw on the Clutch
Mount Assembly. Retighten clamp screw.
Your installation is complete! Affix the enclosed "Care Instructions" to an inside wall of the
cabinet for future reference.
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
6
8 & 9
10
11
Publicidad
