Installation - Homewerks Worldwide HTR-REV02-L Manual Del Usuario

Model #HTR-REV02-L
www.homewerksww.com
All manuals and user guides at all-guides.com
Instructions
8. Connect wiring
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING

INSTALLATION.

CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN ACCORDANCE WITH LOCAL
CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR
WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE SERVICES OF A
QUALIFIED ELECTRICIAN.
WARNING: THIS UNIT MUST BE WIRED ON A SEPARATE 20 AMP CIRCUIT.
WARNING: If your house wires do not match these colors, you must determine what
each house wire represents before connecting and you may need to consult
an electrical contractor to determine this safely.
8-1. Follow all local electrical and safety codes.
8-2. NEVER place a switch where it can be reached from a tub or shower.
8-3. Connect wires as shown in Fig. 6.
8-4. Using wire nuts, connect house power wires to fan wires.
8-5. 14 AWG (2.1 mm 2 ) is the smallest conductor that shall be used for branch-circuit wiring.
Each power wire (Light, Fan, Heater) must have its own switch to operate independantly.
POWER
NEUTRAL
GROUND
9. Operation
CAUTION: FAILURE TO SECURE THE REFLECTOR SCREWS MAY RESULT IN A RATTLING
OR HUMMING NOISE.
9-1. Turn on the LIGHT switch to turn on the light bulb.
9-2. Turn on the VENT switch to operate the fan mode.
9-3. Turn on the HEAT switch to operate the heater mode.
Fig. 6
Item# 398999
8
Effective/Rev. date: March 15, 2012