Gb Mitre Saw - ALPHA-TOOLS 22676937 Manual Del Usuario

GB
Fitting and usage instructions for oblique mitre saw
Before use, read attentively the usage indications.
Intended use
This product is suitable for multi-angle cutting of different types of materials, such as wood, plastic, aluminum, etc.
Specification
Cutting width at 90°
Cutting width at 45°
Cutoff height (max.)
Table length
Table width
Blade length
Blade width
Cutting angle, in degrees: 15°, 22,5°, 30°, 36°, 45°, 90°
List of accessories
1. Horizontal vice
2. Vertical vice
3. Adjustment screw
4. Platform foundation
5. Washer
6. Seat screw
7. Angle sheet
8. Shaft angle
9. Adjustment screw of shaft angle
Technical data
8
12
22,5°
15°
1. Saw cutting table:
2. Saw blade:
3. Adjusting the depth of cut:
4. Rip fence:
Control indications
Please read carefully the instructions and check before installation if there are all mentioned individual parts.
1. Locate firstly the foundation platforms (4) at the ends of the cutting table (12) and secure them with seat screws (6)
2. Insert shaft angle (8) into round opening of the angle sheet (7). Place the cutting table (12) so that its bottom to point upward. Then beat
carefully the shaft angle (8), with a wooden hammer, in the cutting table (12) and fasten the shaft angle (8) with adjustment screw of shaft
angle (9) through the round opening on the angle sheet (7). Secure the position sensor (10) with the screw (11) on the angle sheet (7). Then
mount the two adjustments screws (3) so that the angle sheet (7) to be durable fastened with cutting table.
Remark: The size between the left side, right side, upper and inner side of the angle sheet (7), and cutting table, must not be overly large, in
order to get a vertical position between the toothed blade and the cutting table.
3. Adjust the cutting depth using the rip fence and fasten the adjustment screw (3). Adjust the saw support (15) with the rip fence.
4. Screw vertical vice (2) and horizontal vice (1) on cutting table (12), depending on the desired setting.
Art.Nr. 22676937
160 mm
110 mm
100 mm
400 mm
76 mm
550 mm
45 mm
10. Position sensor
11. Screw position sensor
12. Cutting table
13. Bolts blade saw
14. Saw grip
15. Saw support
16. Saw blade
17. Nozzle guide
18. Saw tailpiece
6 4
5
30° 45°
36°
Stable cutting table of high quality iron, coated with anticorrosive paint.
In addition to automatic blocking selected angle, as shown above, by screw driving it can adjust any
desired cutting angle.
Grip with blade which can be changed:
Saw equipped with standard adjustable saw blade. For iron must be fixed a special saw blade
(not included in the delivery).
The depth of cut can be adjusted by screws.
Four rip fences provide a solid and accurate guidance of the saw frame.
18
3
9
12
4
5
6
90°
20
17
16
14
15
3
13
9
7
1
4
8
5
6
2
11
10
03/2018