Crayola Glow Station On the Go Guia De Inicio Rapido

D
Loading and Changing Batteries
CAUTION:
BATTERIES MUST BE INSTALLED BY AN ADULT ONLY.
REQUIREMENTS: 3 AAA Alkaline Batteries (not included), Phillips-head Screwdriver
1. Use the Phillips-head screwdriver to loosen the screw at the bottom of the Light Wand. The battery cover will
automatically come away from the handle.
2. Remove the battery cover and insert three (3) new AAA alkaline batteries. Ensure that the direction matches
the diagram inside the battery case. (If replacing batteries, remove used batteries and dispose of properly.)
3. Replace the battery cover and re-tighten the screw.
Getting Started
ON
1. Turn on Light Wand.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Contents and colors may vary.
Keep instructions for future reference.
A
B
Canvas
2. Use stencils to color in
shapes with light.
LED Product
3. Color in light texture sheets
to get lifelike effects.
CODE #: 95-1001-0-100
BATTERY SPECIFICATIONS & CAUTIONS
Class 1
3 AAA Batteries 4.5 V (DC)
• Do not use rechargeable batteries.
• Non-rechargeable batteries are not to be recharged.
• Different types of batteries or new and old batteries are not to be mixed.
• Batteries are to be inserted using correct polarity.
• Remove exhausted batteries as soon as possible and discard properly.
• Remove all batteries from compartment if toy is not used for a long
period (several months).
• The supply terminals are not to be short circuited.
Contents
A. Glow Station On The Go D. Stencil Shapes
B. Light Wand E. Stencils
C. Texture Sheet
Storage Pocket
(Located on back of unit)
For Best Results
1. Peel off protective film from Glow Station's canvas.
2. Use in a dark room. The darker the room, the brighter
your art will glow.
3. Hold the wand at different distances from the canvas
to create different effects. The closer the Light Wand
is to the glow surface, the brighter your art will glow.