Crayola COLOR EXPLOSION GLOW DOME Manual De Instrucciones

D
Installing and Changing Batteries
CAUTION:
BATTERIES MUST BE INSTALLED BY AN ADULT ONLY. REQUIREMENTS: 3 AA Alkaline Batteries (not included), Phillips Screwdriver.
1. Use Phillips screwdriver to loosen two (2) screws from the battery cover
under base.
2. Remove the battery cover. If replacing batteries, remove used batteries and
dispose of properly.
Getting Started
1. For best results, work on a clean, dry surface. Remove dome and set it aside. Pull out the center
panel and lay it flat. 2. Choose the scene you want to animate. Carefully cut off the bottom strip along
dotted lines. Then cut the strip in half so the 2 smaller dome decorations can be traced separately.
3. Lay the flat panel over the scene, matching the panel edges to the outline of the template.
4. Use the Glow markers to trace the main scene onto the panel. When you are finished tracing, slide the
panel back into the Glow Dome base.
and press it against the inside wall with one hand. Trace the design with the Glow Markers on the outside
6. Move the design around or use the other decoration sheet and trace as
of the dome wall. D
desired. Mix designs and colors around the entire dome for best results, leaving some open areas to
view the scene on the inside panel. 7. Place the dome back on the base.
Start Your Light Show
Slide the ON/OFF switch under the base to the ON
position. For the best effect, turn off the room lights.
OFF 1 2 3
To Activate Light Feature, Move Slider:
1 click: Light up the inner panel; 2 clicks: Light up the
outer dome only; 3 clicks: Light up both the inner panel
and outer dome; 4 clicks: Light flashes between inner
panel and outer dome.
To Activate Dome Rotation Feature, Press Button:
1 Time: Slow ; 2 Times: Medium ; 3 Times: Fast
To Decrease Dome Rotation Speed, Press Button:
1 Time: Dome slows to Medium speed; 2 Times: Dome
slows to Slow speed; 3 Times: Dome stops.
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
BATTERY SPECIFICATIONS & CAUTIONS
3 AA Batteries 4.5 V (DC)
• Do not use rechargeable batteries.
• Non-rechargeable batteries are not to be recharged.
• Different types of batteries or new and old batteries are not to be mixed.
• Batteries are to be inserted using correct polarity.
• Remove and discard exhausted batteries properly as soon as possible.
• Remove all batteries from compartment if toy will not be used
for a long period (several months).
• The supply terminals are not to be short-circuited.
E
5. Place one of the small decoration sheets inside the dome
E
Cleanup
Note: Keep base away from water to
avoid damage to electronic components.
1. After each use or if you wish to
change artwork, remove panel and
4
dome for cleaning. Use a soft, damp
cloth or paper towel to remove marker.
Dry thoroughly before placing back on
the base. 2. If artwork is left on dome
or plate for a long period of time, it may
be necessary to use mild detergent and
water to clean. Do not use cleaners
containing alcohol, ammonia or
abrasives on plastic surface. 3. Use a
soft, dry cloth to remove any remaining
white fogging on dome or panel.
Contents and colors may vary.
Keep instructions for future reference
CRAYOLA GLOW DOME MARKERS
ARE CERTIFIED AP.
TM
C
B
A
3. Insert three (3) AA alkaline batteries and match direction to diagram
inside battery case.
4. Replace battery cover and re-tighten screws.
A
A
B
B
C
CODE #: 74-7025-0-100 STYLE #: 74-7025
STAIN ADVISEMENT
Crayola Color Explosion Glow Dome markers contain colorants that may stain.
Contents
A. Glow Dome Base D. 6 Glow Dome Markers
B. Center Panel E. 2 Create-A-Scene
Tracing Sheets
C. Outer Dome
D
E