Fax Service Class 1 commands
Built-in DTE interface:
DTE speed up to 115,200 bps
16C550 UART interface
System Requirements
A notebook or desktop computer with PCMCIA
type II or III slot.
A telephone line with RJ-11 jack.
A CD-ROM drive.
Windows 95/98/ME/2000/XP/NT pre-installed.
Hardware Installation
1. Locate the PCMCIA slot of your system.
2. Align the PCMCIA FAX MODEM 56K PC
Card toward the PCMCIA slot. Push evenly and
steadily until it is seated.
Notebook
3. Connect the other end of the PC Card cable to
the telephone line outlet.
4. You are now ready to continue the software
installation.
For Windows NT does not support "Hot
Insert/Remove", be sure to complete the
Connects to RJ-11 phone jack
- 2 -