DeWalt D28114 Manual De Instrucciones página 11

4-1/2 and 5 Sanding Flap Discs
" "
Type 27 guard
hubbed sanding
flap disc
3. With the guard latch open, rotate the guard (I) into the desired
working position. The guard body should be positioned
between the spindle and the operator to provide maximum
operator protection.
4. Close the guard latch to secure the guard
on the gear case. You should not be able
to rotate the guard by hand when the
latch is closed. Do not operate the grinder
with a loose guard or the clamp lever in
open position.
5. To remove the guard, open the guard latch, rotate the guard so
that the arrows are aligned and pull up on the guard.
Type 27 guard
Quick-Change
backing flange
non-hubbed sanding
flap disc
threaded clamp nut
I
9
NOTE: The guard is pre-adjusted to the
diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting screw
(P) with clamp lever in the closed position.
CAUTION: Do not tighten the adjusting
screw with the clamp lever in open position. Undetectable damage
to the guard or the mounting hub may result.
CAUTION: If guard cannot be tightened by adjusting clamp, do
not use tool and take the tool and guard to a service center to repair
or replace the guard.
OPERATION
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing
or accessories.
Guards and Flanges
It is important to choose the correct guards and flanges to use
with the grinder accessories. See pages 7–9 for the correct
accessories.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Every unthreaded accessory must have a 7/8" arbor
hole. If it does not, it may have been designed for a circular saw and
should not be used. Use only the accessories shown on
pages 7–9. Accessory ratings must be above listed minimum
wheel speed as shown on tool nameplate.
P
attachments