Sears Kenmore 116.38099 Manual Del Propietário página 12

TO REPLACE DUST BAG
Fold the safety
seal tab on the
new dust bag
away from the
opening that
fits on the dust
tube.
Dust Bag
Seal Tab
Note: See Parts and Features for bag
ordering number.
Unfold the new dust bag,
Insert the dust
bag onto the
dirt tube com-
pletely by hold-
ing the bag col-
lar and pushing
it onto the dirt
tube.
Position the
dust bag
cover so its
positioning
tabs fit into
the body
positioning
slots,
Cover
Tabs
Close the bag
cover.
You will hear a
distinct snap
when cover is
securely
closed.
Check the motor filter frequently and clean
when dirty.
Electrical Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed to
prevent motor failure andlor electri-
cal shock.
Always unplug power cord from
electrical outlet before performing
any service on vacuum,
Remove the dust cover and dust bag.
If the filter, located in the bottom of the dust
bag cavity is dirty, remove it by pulling for-
ward out from under the ribs°
Motor
Safety
Wash the foam filter in warm soapy water,
rinse and dry thoroughly by squeezing the
filter in your hand and letting it air dry.
DO NOT wash in the dishwasher,
DO NOT install damp.
Replace the foam filter by sliding it back into
place under the ribs in the dust bag cavity,
12