Installation Instructions - Draw-Tite 60953 Instrucciones De Instalación

Ocultar thumbs

página de 6

/ 6
Marcadores

Idiomas disponibles

Equipment Required:

Fastener Kit: KA-8002-249

Wrenches: 11/16", 3/4"

Drill Bits: - None

Qty. (2)

BOLT CARRIAGE 7/16" - 14 X 1 1/2" GR 5

Qty. (2)

WASHER CONICAL TOOTH 7/16"

Qty. (2)

NUT – 7/16"

Qty. (1)

BOLT CARRIAGE 1/2"-13 X 1 1/2" GR 5

1. Thread bolt leader (9) onto end of carriage bolt (1) and insert bolt leader through reinforcing plate (7). Fish the bolt leader and

assembly through the access hole in frame and carefully pull through existing hole in frame until bolt is in position. Leave bolt leaders

attached so the hardware does not get pushed back inside the frame. Repeat for other side of vehicle.

2. Install 1-1/2" carriage bolt (4) through square hole in hitch and vehicle's tie down loop from driver's side. Install clamping block (8)

and conical toothed washer (5) and nut (6) and hand tighten to hold hitch in place.

3. Fish bolt leaders through holes in hitch's frame straps and being careful not to push bolt assemblies back into frame channels,

raise hitch's frame straps up to vehicle's frame, remove bolt leaders and install conical toothed washers (2) and nuts (3).

4. Tighten all bolts, referring to torque table on instruction sheet.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.