Special Safety Directions For The Device - Grizzly AAS 108 Lion Traducción Del Manual De Instrucciones Original

GB
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less Iikely to
bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result in
a hazardous situation.
5) CAREFUL HANDLING AND USE OF
BATTERY DEVICES
• Charge the batteries only in charg-
ers that are recommended by the
manufacturer. Risk of fire if a charger
that is suitable for a specific type of
battery is used with other batteries.
• In the power tools, use only the
batteries designed for the purpose.
The use of other batteries may result
in injuries and risk of fire.
• Keep the unused battery away from
paper clips, coins, keys, nails, screws
and other small metal objects, which
could cause bridging of the contacts.
A short circuit between the battery
contacts may cause burns or fire.
• If used incorrectly, liquid may leak
from the battery. Avoid contact
with this. In the event of accidental
contact, rinse off with water. If the
liquid gets into eyes, seek medical
assistance. Leaking battery fluid may
cause skin irritations or burns.
78
6) SERVICE
• Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
Special Safety Directions for
the device
1) SPECIAL SAFETY INSTRUCTIONS
FOR RECIPROCATING SAWS
• Hold the electric tool by the insu-
lated gripping surfaces when per-
forming work in which the cutting
tool may come into contact with
hidden wiring. Contact with a live
wire can also cause a charge in metal
parts of the device and result in an
electric shock.
• Keep hands away from the sawing
area. Do not reach underneath the
work piece. Upon contact with the
blade there is a risk of injury.
• Check the material to be processed
for foreign bodies, such as nails,
screws etc. which must be re-
moved.
• Only when the electric tool is
turned on should the sawing blade
be moved against the work piece.
There is a risk of kickback if the tool
insert jams in the work piece.
• Make sure that the footplate or
branch support is securely placed
against the workpiece during saw-
ing. The saw blade can tilt and lead
to loss of control over the power tool.
• After you have finished work, turn
the power tool off and do not pull
the saw blade out of the cut until it