Charging The Battery Pack - HoMedics COMFORTPRO TRANSFORM Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 5

CHARGING THE BATTERY PACK

The battery pack is stored in a small pocket on the inside of the
wrap. It can be charged while the product is in use if desired, but the
heat function is not available while charging. Alternatively you can
disconnect the battery pack from the product to charge it.
To check the battery pack charge at any time – press the button on the
side of the pack.
Four blue indicator lights = full charge.
No lights = no charge remaining.
To charge:
1. Ensure that the device is switched off (power button is not lit).
2. Plug the micro USB end of the charging cable provided into the
INPUT socket of the battery pack.
INSTRUCTIONS FOR USE:
FIG 1
1. Locate the USB cord which is attached within the inside pocket of
the wrap and plug it into the OUTPUT port on rechargeable battery
pack. (Fig. 1) Pop the battery pack back into the pocket of the wrap.
2. Place the wrap over your shoulders. (Fig. 2)
3. To activate the massage action, press the power button q on the
control pad. Then press the
M
the lowest setting. To increase intensity, press
and a second time for high intensity. (Fig. 3)
4. To change massage program from steady to pulse, press the
button once. Pressing
button a second time will turn the
M
M
vibration off. (Fig. 3)
5. To activate the heat function, press the heat button on the
control pad. To turn off the heat function, simply press the heat
button again. (Fig. 3)
NOTE: You can use the heat without having the vibration.
6. To turn the device off completely, press the power button q.
NOTE: The battery pack will automatically turn off after 2 minutes
of disuse in order to conserve power. To use the battery pack after
it has automatically powered off, simply press the power button
again, and operate the wrap as normal.
FIG 2
button to activate the massage on
once for medium
3. Plug the USB end of the cable into a USB power socket (not
provided).
4. A full charge requires approximately 7 hours. The light indicator on
the battery pack will flash blue while the unit is charging. When
a full charge is reached, the battery indicator lights will all be
illuminated. The vibration mode of the massager can be used while
plugged in and it will continue to charge. However, heat cannot be
used while on charge.
5. Once fully charged, unplug and remove the charging lead from the
battery pack. The battery should last for up to 4.5 hours of cordless
use.
FIG 3
NOTE: There is a 30 minutes auto shut-off on this appliance for
your safety. This feature should not be considered as a substitute
for 'OFF'. Always remember to switch the appliance off when not
in use.
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean the
surface of the fabric only with a soft, slightly damp sponge.
• Never allow water or any other liquids to come into contact with
the battery pack or USB leads.
• Do not immerse in any liquid to clean.
• Never use any chemical cleaning agents.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact
with sharp edges or pointed objects which might cut or puncture the
fabric surface.
GB
2
I

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hcm-trw210h-eu

Tabla de contenido