Product Features - HoMedics MIR-SR900-EU Manual De Instrucciones

PRODUCT FEATURES

TO ACTIVATE THE MIRROR
Press the power button q on the back of
the light ring to activate the product. Once
activated, the light ring will illuminate
automatically each time you approach the
mirror and will turn off approximately 10
seconds after you have moved away.
To de-activate the product – press the
power button again. This will prevent the
light ring coming on.
TO CHANGE MAGNIFICATION
One side of your mirror is true size (1x),
the other is a close-up detail mirror (7x).
To change from one to the other, simply
twist the mirror by pressing on the edge
of the glass.
TO CHARGE
When the charge is getting low, the green
LED on the back of the light ring will flash
rapidly.
1. Plug the charging cable into the USB
charging port on the back of the light
ring.
2. Plug the other end of the cable into a
USB power outlet.
3. The green LED will begin to flash
slowly, indicating its charging.
4. When fully charged, the green LED will
stay lit constantly, until disconnected
from the power source.
A full charge takes around 5 hours and will
provide up to 8.5 hours of illumination.
CLEANING & CARE
• NEVER clean the product while it is charging. Always unplug
first.
• Wipe over with a slightly damp cloth, avoiding the charging
port, and dry immediately.
• DO NOT submerge the product or use excessive water while
cleaning.
• A domestic glass cleaner may be used to clean the mirror glass.
• Never use abrasive, or any other chemical cleaning agents.
TROUBLESHOOTING
If the light does not illuminate as you approach, press the power
button once to ensure the mirror is activated, then try again. If it
still does not illuminate, please charge the mirror using the USB
cable provided.
GB
2 I