Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
I 0. On support leg end of generator, slide handle onto
center of top of frame.
I I. Attach handle using two long (MS x 45ram) cap screws
and two locking hex nuts.Tighten
with a I/2" or 13mm
socket and wrench.
12. Return
generator
to normal operating
position
(resting
on wheels
and support
leg).
BEFORE
STARTING
THE
ENGINE
Add Engine Oil
• Place generator
on a level surface.
CAUTION
. Refer to engine operator's
manual
for oil fill information.
. Damage
to equipment
resulting
from failure to follow this
instruction
will void warranty.
• Refer to engine operator's
manual and follow oil
recommendations
and instructions.
NOTE:
Check
oil often during engine break-in.
Refer to
engine operator's
manual for recommendations.
NOTE:
The generator
assembly
rotates
on a prelubricated
and sealed ball bearing that requires
no additional
lubrication
for the life of the bearing.
Add Fuel
NOTE:
This gasoline engine
is certified
to operate
on
gasoline. Exhaust
Emission Control
System: EM (Engine
Modifications).
I WARNING
WHEN
ADDING
FUEL
. Turn generator
OFF and let it cool at least 2 minutes before
removing fuel cap. Loosen cap slowly to relieve pressure in
tank.
. Fill fuel tank outdoors.
. DO NOT overfill tank.Allow space for fuel expansion.
. Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
. DO NOT light a cigarette or smoke.
Use clean, fresh, regular UNLEADED
fuel with a
minimum
of 85 octane.
DO NOT use fuel which
contains
Methanol.
DO NOT
mix oil with fuel.
2.
Clean area around fuel fill cap, remove cap.
3.
Slowly add regular unleaded fuel to fuel tank. Be careful
not to overfill.Allow
about 1.5" of tank space for fuel
expansion (Figure 2).
_
_
rTank
4.
Install fuel cap and wipe up any spilled fuel.
Publicidad
Tabla de contenido
