Remington MODSAW Manual De Instrucciones página 4

ASSEMBLY
MOUNT BAR AND CHAIN
1. Rotate guide bar retainer so that it is positioned
parallel to guide bar slot (see Figure 2).
2. Install guide bar onto saw body. Assemble center
slot of guide bar onto guide bar bolt and guide bar
retainer. Note: Make sure the head of the guide bar
retainer slides through the guide bar slot as shown
in Figure 2.
3. Rotate guide bar retainer 90 degrees as shown in
Figure 3.
Drive
Sprocket
Figure 3 - Locking Guide Bar Retainer
4. Place chain around drive sprocket, along top groove
of guide bar, and around guide bar nose. Note: Make
sure cutting edges of chain are facing in right direc-
tion. Position chain so cutting edges on top of guide
bar face guide bar nose (see Figure 4, and indicator
on side cover of saw).
Towards Guide Bar
Nose
Figure 4 - Correct Chain Direction
www.desatech.com
Guide Bar
Guide Bar Retainer
Rotated 90 Degrees
to Guide Bar Slot
Cutting Edge
4
115038