Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting and removing the crevice nozzle
(fig. A)
The crevice nozzle (17) can be used for
vacuuming in narrow and hard-to-reach
places. The crevice nozzle (17) can be
mounted to the hose (7) or to the extension
tube (10).
•
To mount the crevice nozzle to the hose,
insert the hose (7) into the crevice nozzle
(17).
•
To mount the crevice nozzle to the
extension tube, insert the extension tube
(10) into the crevice nozzle (17).
•
To remove the crevice nozzle, pull the
crevice nozzle (17) from the hose (7) or the
extension tube (10).
Use
Unwinding and rewinding the
mains cable (fig. A)
The mains cable rewind button (2) can be
operated by hand or foot.
Before you proceed, we would like you to
focus your attention on the following notes:
-
Do not unwind or rewind the mains cable
while the appliance is switched on.
-
Always hold the mains plug to unwind the
mains cable. Never pull the mains cable.
•
Before use, hold the mains plug and
unwind a sufficient length of the mains
cable from the back of the appliance.
•
After use, press the mains cable rewind
button (2) to rewind the mains cable back
into the appliance. Manually guide the
mains cable to make sure that it does not
swing back. Make sure that the mains plug
is correctly located.
Adjusting the length of the tube
(fig. A)
•
Keep the locking knob (11) pressed and
slide the extension tube (10) to the
required position.
•
Release the locking knob (11).
Adjusting the suction nozzle (fig. A)
The floor surface selector can be set to adjust
the suction nozzle to the required floor surface.
The floor surface selector can be operated by
hand or foot.
•
For vacuuming on laminates, tiles, etc.,
press the corresponding part (A) of the
floor surface selector (14).
•
For vacuuming on carpets, press the
corresponding part (B) of the floor surface
selector (14).
Switching on and off (fig. A)
The on/off button can be operated by hand
or foot.
•
To switch on the appliance, press the
on/off button (1).
•
To switch off the appliance, press the
on/off button (1) again.
Adjusting the suction force (fig. A)
The speed control button can be used to
adjust the suction force.
•
Set the speed control button (1) to the
required position:
- For vacuuming on hard surfaces (e.g.
floors), set a high suction force.
- For vacuuming on soft surfaces (e.g.
upholstery), set a low suction force.
Adjusting the airflow (fig. A)
The airflow can be adjusted using the airflow
control switch.
•
To adjust the airflow, set the airflow
control switch (12) to the required
position.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE
NEUTRAL
BROWN LIVE
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
15
Publicidad
Tabla de contenido
