Essilor FHE 200 Manual De Instrucciones, Uso Y Conservación página 10

Réf. man FHE200
INSTRUCTIONS FOR THE USER
CONNECTION AND OPERATION
Before connecting the device, check that the line voltage corresponds to that
indicated on machine's manufacturer label and that the main switch is set to "0"
(zero).
Place the device on a completely flat surface in order to
ensure maximum stability and take care to leave a free
space of at least 10 cm either side and behind. After
checking that the main switch is set to "0" connect the
power cable, firstly to the body of the device and then
connect it to the plug socket ensuring that it is clear
from the working area which can reach dangerously
high temperatures.
OPERATION
Is done by turning the main switch which lights up to indicate that the device has power
STOP AND EMERGENCY STOP MODES
The normal stop function of the device is achieved by setting the main switch to "0" (zero).
The emergency stop function is achieved by disconnecting the power supply from the plug
socket.
After an emergency stop or a stop due to an anomaly or a power cut, always set the
main switch to "0" (zero).
EXAMPLES
• Start the machine by pressing the main switch(1)
• The machine will be ready to use after approximately 1.5
minutes.
• Place the part of the frame to be softened inside the heat
conveyor.
• Mold the part according to requirements.
• To soften a small surface (bridge, arm), use the heat
concentrator.
Be careful not to introduce any thread-like objects (e.g., arms of the glasses) into the
grills (1) to avoid risking contact with live parts.
Take care to ensure that the power cable is away from the working area which can
reach dangerous temperatures.
LE PRÉSENT MANUEL EST LA PROPRIÉTÉ INTELLECTUELLE DE
Instructions and maintenance manual
Rév. 7/2014
10cm
TOUTE REPRODUCTION EN TOUT OU EN PARTIE EST INTERDITE
EN
Page 10
sur37
10cm
10cm
1