ZAMST A1 Manual De Instrucciones página 2

How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The attachment steps below use the right ankle for reference.
1.
Slide your foot, toes first, into the product with your ankle
at a right angle so that the center of your foot is aligned
to the product's center line.
Center of
your foot
Position of inner
ankle bone
2.
With the soles of your feet on the floor, fasten each hook-
and-loop fastener, while pulling it diagonally upward.
Hook-and-loop
fastener A
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of the member state
in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Center of the
product
Tab
Hook-and-loop
fastener B
3.
Pull the stirrup strap straight up to the extent that it does
not sag, and fasten it.
Stirrup strap
4.
Pull the inversion control strap to fasten it.
z When the strap is pulled diagonally upward:
Stretchable
strap
Non-stretchable
strap
z When the strap is pulled inward (laterally):
Stretchable
strap
When the strap is pulled diagonally upward, inversion is restricted.
When the strap is pulled inward (laterally), side-to-side instability is
suppressed.
5.
Fasten the strap bearing the logo.
<Inner side view (big toe side)>
6.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
Dual inversion
control strap
Dual inversion
control strap
Strap bearing
the logo