Proline SMART16 Manual De Instrucciones página 5

PRODUCT DESCRIPTION
Front View
1
2
3
4
5
6
7
8
1. Take-up lever
2. Upper thread tension dial
3. Pattern selection dial
4. Thread cutter
5. Light
6. Needle clamp screw
7. Bottom bobbin
8. Drawer
9. Hand wheel
Accessories
Foot pedal Thread spool
USING THE FOOT PEDAL AND POWER ADAPTER
1. Connect the power adapter's jack to the DC input socket on the back of the
appliance and plug the power adapter into the mains socket.
2. Insert the foot pedal's jack to the foot pedal input socket on the appliance.
Then you can use the foot pedal to turn on the appliance instead of using the
power off & speed switch.
Caution: Make sure that the foot pedal is disconnected from the appliance
when you are not using it so the appliance won't accidentally start.
NEEDLE REPLACEMENT
If the needle breaks or you need a different needle to sew a different kind of fabric, follow these steps:
Caution: To prevent injury from accidentally starting the appliance, make sure to turn off the
appliance and then remove the foot pedal and power adapter.
Back View
9
10
11
10. Reverse stitch button
11. Power off & speed switch
12. Bobbin winder pin
13. Bobbin winder stop
14. Foot pedal input socket
15. Bobbin winder tension disk
16. Presser foot lifter
17. Presser foot
18. DC input socket
Needle
Bobbin
threader
EN - 3
12
13
14
Needle
15
16
17
18
Power adapter