English - Kenwood CH180 Manual De Instrucciones

Your Kenwood Mini Chopper is suitable
for chopping a range of foods including
nuts, breadcrumbs, meat (raw and
cooked), onions, garlic and fruit purée.
Follow these instructions carefully to
ensure safe and enjoyable use of your
new Kenwood Mini Chopper
safety
The blades are sharp, handle with
care. Hold the knife blade at
the top away from the cutting
edge, both when handling and
cleaning.
Switch off and unplug:
before fitting or removing parts
after use
before cleaning.
Keep hands and utensils out of the
bowl whilst connected to the power
supply.
Remove the knife blade before
emptying the bowl.
Don't let children play with this
appliance.
Never use a damaged appliance.
Get it checked or repaired: see
'service'.
Never let the power unit, cord or
plug get wet.
Don't let excess cord hang over the
edge of a table or worktop or touch
hot surfaces.
This appliance is not intended for
use by young children or infirm
persons without supervision.
Never leave the appliance on
unattended.
This appliance is not suitable for
processing very hard foods e.g ice-
cubes, coffee beans, hard spices,
grinding granulated sugar to caster
sugar, or processing hot liquids.
Never misuse your food chopper
and only use it for its intended
domestic use.

English

before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of the power unit.
This appliance complies with
European Economic Community
Directive 89/336/EEC
before using for the first time
1 Remove all packaging.
2 Wash the parts: see 'cleaning'.
key
lid
knife blade
bowl
drive shaft
control button
power unit
to use your mini
chopper
1 Fit the bowl onto the power unit –
turn in a clockwise direction until it
locks
2 Fit the blade
3 Place the lid onto the bowl and turn
clockwise until it locks
Your mini chopper will not
operate unless the bowl and
lid are correctly engaged.
4 Switch on by continuously pressing
the control button half way down for
speed 1 and all the way down for
speed 2. Alternatively use an on/off
pulse action which will operate the
motor and keep it running for as
long as the button is held down.
5 Reserve the above procedure to
remove the lid, blade and bowl.
2
.
.
.