Assembly - GOK HS-V.2 Serie Instrucciones Para El Montaje Y El Funcionamiento

More information about compression fittings can be found at
www.gok.de/datenblaetter/Schneidringverschraubungen/
Data sheet - Compression fittings.

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport. Installation, maintenance and start-up may only be carried out by companies that
are specialist companies for this work in terms of Section 62 of the German Ordinance on
Facilities Handling Substances Hazardous to Water (AwSV).
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
Metal chips may cause eye injuries.
Wear safety goggles!
Malfunctions caused by residues! Proper functioning is not guaranteed.
Visually check that there are no metal chips or other residues in the connections!
It is important that metal chips or other residues are blown out!
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
Observe the installation direction (marked on the product with an arrow
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection
nozzle. Do not use unsuitable tools, such as pliers.
Application example: Fuel oil consumer installation in single conduit system
Figure 2:
Artikel-Nr. 15 513 50 c
Risk of injuries due to blown-out metal chips!
).
Membrane-controlled
anti-siphon device type
HS-V.2
Pressure
compensation valve
type DAV7
Tank withdrawal
armature type VTK-3
Suction line
Combined heating oil
filter breather
type GS Pro-Fi 3
21 / 60