Intended Use; Technical Data - T.I.P. 18000 3D Traducción De Las Instrucciones De Uso Originales

•
Parts of the packaging can be dangerous (e.g. the plastic bags) - therefore keep these out of reach of
children, people who not responsible for their actions and animals.
•
Only use accessories that are included in the scope of delivery, or only those that are specified in the op-
erating manual. The use of accessories that have not been approved may impair safety.
•
Any use of the device that is not described in this manual may be dangerous and must therefore be avoid-
ed.
•
The device must be correctly assembled with all parts before use. Check that the socket and plug match.
•
Never touch the mains plug with wet hands.
•
Switch off the device before maintenance, cleaning and after use, and unplug from the mains.
•
Do not leave the device unattended, do not leave it within the reach of children or people who are not re-
sponsible for their actions.
•
Children should be supervised so that they do not play with electrical devices.
•
In case of incidents (e.g. contact with cleaning agents or chemicals) clean the machine with plenty of clean
water.
•
In the event of a malfunction, always pull out the mains plug to avoid any danger.
•
Never leave the device unattended during operation.
•
Carefully check whether the mains connection cable, housing or other parts of the device are damaged; if
so, do not use the device under any circumstances and contact the customer service department for re-
pairs.
•
If you are using extension cables, make sure that they are suitable for the application in question and that
they are placed on a dry surface and protected against water spray.
•
Service and repairs shall only be carried out by qualified personnel. Defective parts of the device shall only
be replaced with original parts.
•
The manufacturer is not responsible for any damage to persons or objects caused by improper use of the
device, or by a failure to follow the instructions provided in this manual.
1.1. Special safety instructions for the pool robot and switch box
•
The device shall only be operated in water and never without water, because it may otherwise be dam-
aged. Never use the device without the filter bag.
•
When setting up the switch box, maintain a safety distance of 3 m from the pool.
•
Always fasten your device in a suitable location using the mounting bracket supplied. The switch box must
not be set up loosely on pedestals or similar bases, but only fastened on a level and firm surface or with
the bracket.
•
Always secure the switch box before sliding into the water, the pool robot could possibly pull the switch
box into the pool if it is not secured carefully or if there is insufficient distance to the water.
•
Never use the device if there are people or animals in the water. Avoid working with the device in the rain.
•
Do not move the device by pulling on the cable.

2. Intended use

This device is intended for private use at home and not for commercial or industrial purposes. Only use the device
to clean and remove dirt in pool systems.
The device is not suitable for cleaning salt water pools. The outside temperature and operating tem-
perature must not exceed or undershoot the maximum or minimum temperatures specified in the tech-
nical data.
The device is only suitable for operation in fixed-wall pools. It is not suitable for pop-up pools, infinity
and deck-level pools, and pools with built-in steps.

3. Technical data

Model
Motor
Switch box output voltage
Switch box input voltage
Connection cable
Mains cable
Max. flow rate
Max. immersion depth
Sweeper 18000 3D
150 watts
24 V (DC)
230 V~ / 50 Hz
18 m
1.8 m
18,000 l/h
3 m
2
9