Pairing Your Btc 700 With Other Bluetooth Equipment; Erase All Paired Records; Connecting/Disconnecting Your Btc 700 With Bluetooth Equipment - Vivanco BTC 700 Manual Del Usuario

5. Continue to follow on-screen prompts to enter passkey "0000"and confirm to pair the
BTC 700 with your handset. Once the pairing procedure is completed, you will hear
a connecting tone, and then Blue LED gives 3 quick blinks per 2 seconds. It indicates
that the BTC 700 device and the handset are paired and connected.
：
Note
1. If pairing is successful, BTC 700's Red LED is off. The Blue LED gives 3 quick
blinks per 2 seconds. If paring is failed
continuously (for about 2 minutes). You need to go back to above steps 3-5 to repeat
the paring process.
2. Your BTC 700 will remain in the pairing mode for about 2 minutes. If paring cannot
be finished within 2 minutes, the BTC 700 will enter into the standby mode (without
Bluetooth connection in this case). You need to repeat the above steps 2-5 to restart
the pairing process.

2.4.2 Pairing your BTC 700 with Other Bluetooth Equipment

In addition to Bluetooth phone, your BTC 700 can also pair with other Bluetooth equipment
for realizing short distance wireless communications. Similar pairing procedures described
in the previous Section can be used. You can follow the user guide of the Bluetooth
equipment to complete paring operations on the equipment side.
This BTC 700 can be paired with up to 8 Bluetooth equipments (including mobile
handsets). The corresponding 8 sets of pairing information are recorded by the BTC 700.
Each paired equipment can wireless communicated with the BTC 700 after setting up a
Bluetooth connection. Please check Section 2.4.4 on procedures to set up a Bluetooth
connection.

2.4.3 Erase all Paired Records

This BTC 700 can be paired with up to 8 Bluetooth equipments. When BTC 700 in the
Paring Mode, long press K4, it will erase all paired profiles and quit pairing mode. At this
time, Blue LED gives 1 blink per 3 seconds.

2.4.4 Connecting/Disconnecting your BTC 700 with Bluetooth Equipment

When the BTC 700 communicates with a Bluetooth equipment with Handsfree Profile, the
Bluetooth connection between two equipments shall be established in advance. If two
Bluetooth equipments have been paired recently, you can simply reconnect them.
Connecting your BTC 700 with Bluetooth Handset：
Initiating a request from either the BTC 700 or the handset can set up Bluetooth connection.
The detailed operations are as follows:
1. Initiating connection request from the BTC 700: Place the BTC 700 close to the
Bluetooth handset and then short press K2.
，
the Blue and Red LEDs alternate
10