Ringtone Selection; Opening The Gate - Expondo STAMONY ST-VP-300 Manual Del Usuario

1 2
3) Loosen the four screws on the back of the outdoor
station.
3
4) Connect the cable in accordance with the connection
diagram (section 3.2.3) and adjust the volume.
4
5) Remove the plate and write the name / apartment
number or other data on it.
5
1
2
6) In the appropriate hole in the wall (110x158x57 mm,
1.4-1.7 m high) fix the installation box with screws.
6
EN
7) Fasten the outdoor station to the installation box
and tighten the screws with the enclosed wrench.
7
3.2.2. INDOOR MONITOR INSTALLATION
Fasten the monitor holder to the wall with screws. Connect
the wiring according to the diagram (section 3.2.3)
After connecting the cables, place the monitor on the
holder, connect the power adapter, and then connect it to
the socket.
Caution: When choosing the mounting location for internal
monitors, refer to the guidelines in sections 2 and 3.4.
3.2.3. ELECTRIC SCHEMA
Outdoor station Monitor A
Monitor C Monitor B
10
Cables:
1. Audio
2. Grounding
3. Video
4. Power supply
8. Audio
Description:
1. Ports 2,3,4 on the outdoor station should be
connected to terminals 2, 3, 4 on the indoor monitor
A and B.
2. Connection 1 on the outdoor station should connect
to connection 1 on indoor monitor A.
3. Connection 8 at the outdoor station should connect
to terminal 1 on indoor monitor B.
4. Connection 6, 7, 8, 9 on monitor C should be
connected to connections 6, 7, 8, 9 on monitor B.
5. Connection + - on the internal monitor A, B and C
should connect to the charger.
6. Connections 5.6 at the outdoor station should be
connected to an electric lock.
Cable type: 4 connecting cables (4-wire RVV).
Maximum working distance: 50m.
3.3. DEVICE USE

3.3.1. RINGTONE SELECTION

1) To select the ringtone melody, press the camera
preview icon for 4 seconds until you hear a
characteristic sound.
2) Press again to change the melody.
3) To accept the selection, press the door open icon.
1 2 3
4) To set the ringer volume, press the camera preview
icon again for 4 seconds.
5) Then press the conversation start icon to adjust the
volume.
6) Accept the settings by pressing the door open icon.
4 5 6
7) To mute the monitor, press the door open icon for
4 seconds until you hear a characteristic sound.
The LED indicating the mute mode will light up
on the top of the monitor. When the connection is
established, the monitor will not ring, only the image
will be visible.
7
EN
3.3.2. CALLING
Press the first button on the outdoor station to connect to
monitor A. To connect to monitor B and C, press the second
button on the outdoor station. The monitor will then emit
sound in accordance with the settings and the screen will
show the image recorded by the camera of the outdoor
station.
In order to start a conversation with a person outside, press
the icon shown in the figure. At the same time, the voice
connection indicator on the top of the monitor lights up.
Caution: After pressing the conversation start icon on
monitor B, monitor C will hang up.
To end the conversation, press the icon indicated in the
drawing again.
Caution: During the conversation it is possible to set the
volume, brightness and contrast of the screen.
3.3.3. 3.3.3. OPENING THE DOOR
To open the door, press the icon shown in the figure.

3.3.4. OPENING THE GATE

To open the gate, press the icon shown in the figure.
11