Forch 6260 2800 Manual Del Usuario página 15

CAUTION! If wall-mounting:
Before drilling the holes, check that there are no electrical lines, gas or water pipes, or other
auxiliary lines behind the chosen area on the wall. The installer is responsible for the secure
mounting of the unit.
Use correct fixing materials. Before installation, check that the wall has the required load-
bearing capacity to mount the dispenser securely.
There is a risk of injury if the unit is not mounted correctly.
The wall mounting kit is included in the packaging. To mount the unit on the wall, carefully
drill the holes according to the size of the supplied dowels.
Secure the wall mounting plate to the wall using a suitable screwdriver (the upper side is
clearly labelled).
To fasten the dispenser to the wall mounting plate, place the lower side of the dispenser to
the lower edge of the wall mounting plate and slide it upwards. Then hook the upper side
of the dispenser over the upper edge of the wall mounting plate. Check for correct fit and
secure fastening on the wall before inserting the filler and hardener cartridges.
Fig. 2
ATTENTION! The release handle (7) must be opened as far as possible with each use.
Check that both channels fully open when the handle (6) is pressed down.
Operation:
1. Push the release buttons (3 + 4) upwards until they lock into place.
The sliding bars (1 + 2) can now be moved up and down.
2. Remove the lid of the filler tin and the hardener cartridge, as well as the cover on the
underside of the filler tin. (see Fig. 2)