Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
38
WARNING:
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
Batteries must not be disposed of in the garbage. Please
bring used batteries to competent collection centers or
back to the dealer.
Reestablishing factory settings
Possible malfunctions during the operation may be remedied
by pressing the RESET button (2).
• Press the reset button (RESET) on the remote control to
reset the electronics. The settings made by you and the
stored radio stations will get lost in the process.
General Operation
Switch device on/off
• Turn on the device with the power switch on the back. Set
the POWER switch to the "ON" position.
• With the button (14), you can switch the unit between
standby and operating mode. When in standby, two bars
are lit in the display.
• To turn off the device, set the power switch POWER on
the back to the "OFF" position. To disconnect the unit
completely from the mains, pull the mains plug from the
socket.
NOTE:
After about 30 minutes without signal, or if the signal is too
weak, the device will automatically switch to standby.
Volume
By pressing the
/
buttons (7/10) you can adjust the desi-
red volume.
Infrared Remote Control
For wireless control within a distance of 5 m. If this range de-
creases, the battery has to be replaced. For proper operation
mind a clear view between the remote control and the sensor
on the device.
INPUT (1)
Press the INPUT button until the desired operating mode is
shown on the display.
All manuals and user guides at all-guides.com
Sound Settings (4)
(Preset equalizer function). Different sound modes are availa-
ble (NORMAL, MUSIC, MOVIE).
If necessary, change the EQ setting in your playback unit to
create the best sound.
Adjusting basses and trebles (13)
The basses are adjusted with the BASS+/BASS- buttons.
The trebles are adjusted with the TREBLE+/TREBLE- buttons.
For immediate muting of the volume. The currently set
volume will flash in the display. Press
function.
Radio mode
1. Fully uncoil the wire antenna. Insert the dipole antenna
2. Manual scan for radio stations:
3. If the reception is too weak and there is interference on
Select the preset radio station
The preset radio stations can be selected by repeatedly
pressing the CH+/CH- button (11).
NOTE:
(3)
into the FM ANT jack (4).
Briefly press the >>/<< button (6), until you have found
the radio station which you are looking for. If you keep
one of the buttons pressed down, the device will search
to the previous, respectively next radio station.
Preset station:
1. Search for the desired radio station with the >>/<<
buttons (6).
2. To store the radio station, keep the CH+ button (11)
pressed down for ca. 3 seconds. The notification
"P 01" flashes on the display.
3. Use the CH+/CH- buttons to select the desired
preset location.
4. Keep the CH+ button pressed down again for ca. 3
seconds. The radio station will be stored.
the received station, try to improve the reception by
altering the position and uncoiling or coiling the antenna.
For FM stations, you can use the ST/MONO button (8) to
switch between mono and stereo reception. We recom-
mend that you switch to mono in case of bad reception.
The message "ST" is shown on the display for stereo
reception. During reception in mono "SOFF" will appear
briefly in the display.
again to cancel the
Publicidad
Tabla de contenido
