Uline H-8867C Instrucciones De Montaje

H-8867C, H-8868C, H-8869C
H-8871C, H-8872C, H-8873C
CLAMP-ON PRIVACY
PANEL
TOOLS INCLUDED
Allen Wrench 3 mm
Allen Wrench 5 mm
Mounting Bracket x 2
1. Separate bracket into front and rear pieces. Firmly
press one plastic mat to each inside wall. Place
panel into opening of mounting bracket. To secure
mounting bracket to panel, insert a M6 x 12 mm
Allen screw and fully tighten using 5 mm Allen
wrench. Repeat step for bracket on opposite end of
panel. (See Figure 1)
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
PARTS
Plastic Mat x 4 Allen Screw x 2
M6 x 12 mm
INSTRUCTIONS
Set Screw x 6
M6 x 8 mm
2. Position panel in desired location and slide
mounting brackets over edge of tabletop. Insert
three M6 x 8 mm or M6 x 15 mm set screws into
underside of each mounting brackets and tighten
using 3 mm Allen wrench to secure panel to
tabletop. (See Figure 2)
NOTE: Do not overtighten screws to avoid
damage to underside of tabletop.
NOTE: For 1" tabletops, use M6 x 8 mm screws.
For 3/4" tabletops, use M6 x 15 mm screws.
Figure 2
Para Español, vea página 2.
Pour le français, consulter la page 3.
Set Screw x 6
M6 x 15 mm
0321 IH-8867C