Assembly Instructions - Weston 36-3801-W Manual De Instrucciones

IMPORTANT NOTE PRIOR TO USE
A protective coating is applied to this unit prior to shipment. This coating
protects the unit in shipment and during it's shelf life.
It is very important to thoroughly clean the unit before using it, especially
around the edges or areas that have been soldered or welded. Completely
disassemble and thoroughly clean all parts with hot water, dish detergent and
a soft cloth. Rinse with clean water and dry thoroughly. DO NOT use any
harsh or abrasive brushes, chemicals or detergents. (Avoid using detergents
or cleansers containing high percentages of free alkali or acid.)
DO NOT clean any parts of this unit in a dishwasher.
Coat all metal parts with a food-safe silicone spray after cleaning and before
storing.
Be certain to store the unit in the original box in a cool, dry location.
Run a small "Test Batch" through the unit before initial use.

ASSEMBLY INSTRUCTIONS

1. Slide the Protector Pad(s) onto
the feet of the Juicer and tighten
the Clamp Thumscrew to secure
the Juicer to the work surface.
Allow ample room for the Handle
to spin freely.
2. Insert the Screen, narrow end
first, bowed edge facing down,
completely into the Juicer Body
from the back of the Juicer. The
Screen will fit tightly into the Juicer
Body. FIGURE 1
3. Place the Auger into the
Grinder Body, so it rests on top
of the Screen (FIGURE 2). The
Auger Shaft will remain outside of
the Juicer Body.
All manuals and user guides at all-guides.com
Screen
CAUTION!
The Screen has very
sharp edges.
The Screen fits into the
Juicer Body very tightly.
Use a pair of needle-nose
pliers to carefully remove
the Screen from the
Juicer Body for cleaning.
Auger
Auger
Shaft
Juicer
FIGURE 1
Body
Juicer
FIGURE 2
Body
5