Kettler 08452-600 Instrucciones De Montaje página 6

GB
■
Please ensure that the wheeled toy is only used in surroundings free of danger.
■
This wheeled toy does not have lights. It is dangerous to use it in the dark.
■
Caution: While assembly of the product keep off children's reach (Choking hazard -
!
contains small parts).
Handling
■
Before use always check that all screws and plug-in connections and respective safety de-
vices fit correctly.
■
Instruct children in the correct use of the product, and draw their attention to possible dan-
gers.
■
Sturdy, closed footwear must be worn when using this product.
■
This wheeled toy does not have a so-called parking brake. Therefore secure the vehicle
against rolling away. Do not leave children, who are not old enough to use the wheeled
toy, unattended on a product.
■
If this product can be adjusted please adapt it to your child's height.
■
Do not transport anything on this product.
■
Never use corrosive or abrasive substances to clean the toy. Never use substances which
may cause pollution of the environment.
■
Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil eve-
ry two or three months.
■
For models with pneumatic tyres: When leaving wheeled toys with pneumatic tyres on
floors containing solvents or which have been glued with such solvents (e.g. PVC) they may
possibly stain it due to a chemical reaction with the natural product caoutchouc. If in doubt
place something underneath the wheels. Ensure that air pressure in the tyres is correct (2,5
bar); if air pressure is too low this increases wear, and makes riding the toy more difficult!
Assembly of the toy vehicle
■
The toy vehicle must be assembled carefully by an adult person. Study the assembly in-
structions carefully before beginning work. Assemble the vehicle in the exact sequence
shown by the letters in the diagrams. This is essential for the safe function and use of the
toy vehicle.
■
Please note that there is always a danger of injury when working with tools or doing ma-
nual work. Therefore please be careful when assembling this machine.
■
Ensure that your working area is free of possible sources of danger, for example don't le-
ave any tools lying around. Always dispose packaging material in such a way that it may
not cause any danger. There is always a risk of suffocation if children play with plastic
bags!
■
Bolt all the parts together loosely at first, and check that they have been assembled cor-
rectly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tigh-
ten nuts completely against resistance (locking device). Then check that all screw connec-
tions have been tightened firmly. Attention: once locknuts have been unscrewed they no
longer function correctly (the locking device is destroyed), and must be replaced.
■
When assembling plastic grips: The grips can be pushed onto the handlebars more easily
if they are first soaked in warm water.
■
For technical reasons, we reserve the right to carry out preliminary assembly work (e.g.
addition of tubing plugs).
6
6
All manuals and user guides at all-guides.com