STACK-ON PC-1665-B Manual De Instrucciones página 4

SECURING THE CASE WITH THE CABLE
For optimal performance, the case should be installed
in an isolated, dry and secure area.
THE CASE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
NOTE: is case is designed to be secured with a
cable that is a ached to a xed object. Failure to
to do so will compromise the safety and security
of the case.
To secure the case to a xed object, loop the cable
around the object and place the cable's small end
into the notch on the side of the case. Tip the cable
end down while inserting in the notch. Locking the
case will secure the cable end inside the case.
3
24
P-0454
PA-0803
2
1
NOTE ON LOCKING THE CASE:
needs to be in an upright position, as shown in
gure 1, for optimum performance. Failure to
store the case in the correct upright position will
compromise the safety and security of the case.
FIGURE 1
PTION
TH, STL, ZP
, BO
TL, ZP
HEAD, PH, STL, ZP
2
ALL PRODUCT INFORMATION ENCLOSED ON THIS PROJECT:
DOCUMENT IS PROPERTY OF STACK-ON PRODUCTS. ANY
PC-650-B NEW
AND ALL USE OF THIS INFORMATION WITHOUT CONSENT
OR PERMISSION FROM STACK-ON PRODUCTS IS NOT
PERMITTED.
MATERIAL: FINISH:
N/A
N/A
TURNING THE SOUND OFF/ON
Your case comes with the beep sound turned on.
To turn the sound o , press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear two beeps and
the green light ashes twice.
REV ENG DATE
A PRH 09APR15 08APR15
e case
NOTE:
A
Department of of Justice rearm safety device.
MAINTENANCE
e biometric scanner may be cleaned with
household glass cleaner and a co on cloth.
IMPORTANT
Keep keys in a secure place, away from children.
Keep this record of your serial number in a secure
place separate from your case. To order a
replacement key set, follow the instructions on the
SEE
a ached form.
DETAIL
B
STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
A-A
SECTION
STANDARD TOLERANCES (UNLESS OTHERWISE NOTED)
X 2 [0.1]
DIMENSIONS: MM [IN]
X.X .8 [0.03]
ANGLES:
X.XX .40 [0.015]
DESIGNED BY: DATE:
PRH 08APR15
1
DESCRIPTION OF CHANGE
D
is unit is not an approved California
A
C
B
P-0556
1
A
1
1360 OLD RAND ROAD, P.O. BOX 489
WAUCONDA, IL 60084
PH: 847-526-1611 FAX: 847-526-6599
FORMAT PROE DRAWING NUMBER REVISION
4
12
40657-1512