Honeywell 88101 Serie Manual Del Propietário página 4

Replacing the battery on your remote
BACK OF REMOTE CONTROL
BATTERY
RELEASE TAB
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device. This device complies with Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV
technician for help.
Replacing the batteries in your docking station.
SCREW COVERS
Turn the ON/OFF switch to "OFF." First remove the four screw covers from the bottom of the docking station, next use a phillips head screwdriver to remove the four
screws holding the bottom in place. NOTE: Do not remove any of the connecting wires. Finally remove the old batteries and replace with new Ni-Mh 1000 mAh AA
rechargeable batteries (sold separately). Replace bottom cover by aligning it properly and then inserting each screw into one of the four holes and turning the screws
clockwise until secure, make sure to replace and tighten all four screws. Replace all four screw covers.
Item # 88101x-xx
Gently pull in the release tab towards the battery tray as you
pull the battery tray out. Remove the old battery and replace
with a new CR2025 lithium battery (sold separately). Replace battery cover.
SCREWS
page 4