Aux 2 Source - Naxa NHS-2007 Manual De Operación

AUX 2 SOURCE

sources may include:
AUX 2
- Personal audio players
- Personal computers or laptops
AUX 2 connection:
1. Use a stereo 3.5mm jack cable (supplied) to connect the headphone (or LINE/Audio) output of
the source device (e.g., an iPod) to the AUX 2 audio input jack found on the side of the unit.
2. Turn on the unit. Press the SOURCE button until the indicator turns orange. Start playback on
the source device.
NOTE: If there is no sound or if the volume is not loud enough, try increasing the volume on
the source device.
Connect to the 3.5mm Audio Out jack
of external audio devices including Tablets,
Laptops, Smartphones, MP3 Players, etc.
During playback
- Press the MUTE button to disable the sound. Press MUTE again to reenable the sound.
- Press the VOLUME+/– buttons to adjust the volume level.
- Press the BASS+/– buttons to adjust the bass level.
- Press the TREBLE+/– buttons to adjust the treble level.
- Press the EQ button to switch between POP, JAZZ, CLASSIC, and ROCK equalizer settings.
T o 3 5 . m
3.5mm Aux In Cable (Included)
1 0
m A U X 2 jack on the Sound Bar