Problems And Solutions; Important Notice - Joycare JC-490G Manual Del Usuario

PROBLEMS AND SOLUTIONS

PROBLEM POSSIBLE CAUSE
No power (Light indicator -Unit not plugged in -No
is off ) power at outlet
No air or mist (and light -No water in the unit -Mist
indicator is on) intensity level too low
-Defective components
(Non-serviceable) -Unit not
in a level surface -Possible
mineral deposits on nebulizer
or sensor -Water tank was
washed with detergent
-Nebulizer worn or defective
Water tank is full but no mist -Too much water in the unit
(Light indicator is on)
Damaged plug or cord -Worn insulation -Damaged
or exposed wires -Defective
components (Non-
serviceable)
Water do not fill the reservoir -The hole to let the water
cool down is dirty

IMPORTANT NOTICE

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or
knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children
should be supervised to ensure they do not play with the appliance. If the power cord is damaged it must be replaced by the builder or by its technical
service or, in any case, by a person
holding similar qualification in order to avoid whatsoever hazard.
Class II appliance
This item is made in conformity with all the applicable European directives
DISPOSAL
The device (including its removable parts and accessories) must not be disposed of together with municipal waste at the end of its life, but in compliance
with European Directive 2002/96/EC. Since it must be handled separately from household waste, either carry it to a separately collected waste disposal
centre for electrical and electronic appliances or give it back to the retailer on purchasing a new device with the same purpose. Any infringement will
be severely prosecuted. Specifications and designs are based on the latest information available at the time of printing and subject to change without
notice.
SOLUTION
-Plug the unit in -Check
circuits, fuses, test outlet
with lamp
-Fill water tank -Set intensity
level higher -See warranty
-Place unit on a level surface
-Clean nebulizer and sensor
and refill with distilled water
-Rinse thoroughly with clean
water -See warranty
-Reduce water
-Do not use product, see
warranty -Do not use the
product, see warranty -Do
not use the product, see
warranty
-Clean carefully the hole
5