- Maximal intensity of vapour emission: 5.5 ml/m
- Removable tank's capacity: 3.8 litres
- Power supply: 220-240V~50Hz
- Power: 33W
Operation use conditions:Room temperature: from 10°C to 40°C. Relative humidity: from 30% to 75% without condensation.
Pressure: from 700 – 1060 hPa.
Environmental transportation and storage conditions: Temperature: from 10 to 40°C. Humidity: from 5 to 95%. Pressure: from
700 – 1060 hPa.
PROBLEMS AND SOLUTIONS
PROBLEM
POSSIBLE CAUSE
No power (Light indicator
-Unit not plugged in -No
is off )
power at outlet
No air or mist (and light
-No water in the unit -Mist
indicator is on)
intensity level too low
-Defective components
(Non-serviceable) -Unit not
in a level surface -Possible
mineral deposits on nebulizer
or sensor -Water tank was
washed with detergent
-Nebulizer worn or defective
Water tank is full but no mist
-Too much water in the unit
(Light indicator is on)
Damaged plug or cord
-Worn insulation -Damaged
or exposed wires -Defective
components (Non-
serviceable)
Water do not fill the reservoir
-The hole to let the water
cool down is dirty
Class II appliance
This item is made in conformity with all the applicable European directives
DISPOSAL
The device (including its removable parts and accessories) must not be disposed of together with municipal waste at the end of
its life, but in compliance with European Directive. Since it must be handled separately from household waste, either carry it to a
separately collected waste disposal centre for electrical and electronic appliances or give it back to the retailer on purchasing a
new device with the same purpose. Any infringement will be severely prosecuted.
Specifications and designs are based on the latest information available at the time of printing and subject to change without
notice.
F
HUMIDIFICATEUR À ULTRASONS
L'humidificateur à ultrasons rétablit le correct niveau d'humidité dans l'air pour un soulagement immédiat des voies respiratoires
des adultes et des enfants. Le produit emploie la technologie à ultrasons qui permet de pulvériser les
particules d'eau froide. Les avantages de cette technologie sont le silence et l'absence des effets sur la température de la pièce ;
en utilisant l'eau froide on évite la formation de la vapeur sur les fenêtres, les murs et sur les meubles.
SOLUTION
-Plug the unit in -Check
circuits, fuses, test outlet
with lamp
-Fill water tank -Set intensity
level higher -See warranty
-Place unit on a level surface
-Clean nebulizer and sensor
and refill with distilled water
-Rinse thoroughly with clean
water -See warranty
-Reduce water
-Do not use product, see
warranty -Do not use the
product, see warranty -Do
not use the product, see
warranty
-Clean carefully the hole
7