Fm Radio; Manual Scan - THOMSON RK200DABCD Manual Del Usuario

You may save your preferred DAB stations to the preset station memory. There are 20 memory
presets in your radio. In the event of a power failure, presets are retained by your radio.
The procedure for setting presets and using them to tune stations is the same for DAB modes:
In DAB mode, select the desired wave band, rotate RADIO TUNING to view the stored
stations, then press
then press [ENTER] to select the desired preset number under which you will store the station.
Press [ENTER] to confirm.

FM Radio

Carefully extend the telescopic aerial to its full length.
Auto Scan
1. Press the FUNCTION button to select "FM Mode".
2. Long press the
station of sufficient signal strength.
3. After a few seconds, the display will update. The display will show the station frequency. If the
signal is strong enough and the station signal contains RDS data, then the radio will display
the station name.
4. To find other stations, press and hold the
5. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
6. When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
7. Rotate RADIO TUNING to listen to the available stations

Manual Scan

1. Press the [ FUNCTION ] knob on the main unit to select "FM Mode''.
2. Select FM mode as previously described, if required.
3. Press or
up or down by 100 kHz.
4. When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure that the aerial is extended and test the
reception by doing another auto scan in a different location.
5. Rotate the RADIO TUNING to listen to the available stations.
Menu
1. Scan Setting
In FM mode, press MENU, enter the FM menu setting, then press
setting], then press ENTER to select the sensitivity setting:
1.1. All stations: ~15dB
1.2. Strong stations only: ~19dB,
or to tune to the required station as previously described, and
button, and your radio will scan and stop automatically when it finds a
to tune to a station. Each press of the tuning button will change the frequency
- EN 9 -
button as before.
or to select [Scan