Slide the power switch of camera and receiver to the ON position.
Setting up camera
Adjusting the lens orientation
Place the camera in a convenient location, point the lens towards the
observation area and adjust the angle by rotating the lens body.
Fine Tuning focus
Adjust the focus knob for optimum image.
Connecting the camera to a signal source
Connect one set of Audio/Video cable to AV out jack of the camera.
Connect the other end of the cable to the Audio/Video jacks on the A/V
source labeled line matching the plug color with the jacks on the A/V
source.
A/V source
Setting up receiver
Channel setting
CH1 will be selected by pressing CH button one time, then CH channel
LED
Indicator 1 will light.
CH2 will be selected by pressing CH button one time again, then CH
channel
LED indicator 2 will light.
CH3 will be selected by pressing CH button one time again, then CH
channel
LED indicator 3 will light
CH4 will be selected by pressing CH button one time again, then CH
channel
LED indicator 4 will light
-7-
Connecting the Receiver to a TV
Connect one set of Audio/Video cable to AV out jack of the receiver.
Connect the other end of the cable to the Audio/Video jacks on the TV
labeled line matching the plug color with the jacks on the TV.
AV OUT
Troubleshooting
Please read this owner's manual carefully and follow the steps described
in it, if you still have difficulties, consult the following solution it will guide
you though the most common problem and their solutions.
1. If you are not setting any signal at all
f.
Check the power ON/OFF switches on the camera and receiver.
g. Make sure power plugs are pushed all the way in.
h. Check the channel switch on both camera and receiver are set to the
same number.
i.
If you connect the receiver to a TV, check the cable connections.
2. If the signal is poor, or there is interference
d. Change the channel on both camera and receiver and make them the
same.
e. Make sure the camera and receiver are within range (up to 100m at
open site)
f.
If there is a microwave oven in use in the path between the camera
and receiver, remove the microwave.
TV
Video
Audio L
Audio R
-8-