Cleaning And Maintenance - Joycare JC-1504 Manual De Instrucciones

GB
INSTALLING THE CAR SEAT IN A CAR EQUIPPED WITH THREE-POINT SEAT BELTS
Follow the instructions shown on the label placed on the rear of the backrest. It is recommended that you
attach the car seat to the rear passenger seat, facing forwards.
Position the car seat so that the backrest sits firmly against the back of the passenger seat (fig.5).
Position the seat belt around the child. Pass the lap belt under both armrests (following the directions shown
in red on the booster). Insert the tongue of the buckle into the seat belt buckle and tighten the lap belt so that
it fits closely. Pass the strap back under the armrest and then above the shoulder through the belt loop (shown
in red) on the headrest. For greater safety: pull the strap upwards tightly. Make sure that the belt is not twisted
(fig.6).
MAKE SURE THAT BOTH THE ABDOMINAL AND DIAGONAL BELT PASS THROUGH THE APPROPRIATE HOUSINGS
INDICATED BY THE ARROW. THE RED ARROW INDICATES THE BELT'S CORRECT POSITION (fig. 7).
INSTALLATION WITHOUT BACK SEAT (Only base / booster) Group III (22 kg-36 kg)
Remove the backrest from the booster.
Hold the base with one hand; push the backrest backwards and pull the backrest, with the other hand (fig. 8/9).
Place the forward-facing child seat in the car, on the positions allowed in the car (fig. 10).
After placing the child, pull the car belts to 3 points (lap and diagonal) by means of the buckle. Under the arms,
pull the abdominal seat belt and over the child's shoulder, pull the diagonal, not twisting them. Put the car seat
buckle into the lock mechanism until you hear the locking "click" (fig. 11/12).

CLEANING AND MAINTENANCE

Please be sure to use only original seat covers, as the seat cover is important to the proper functioning of the
system.
The child seat must not be used without the seat cover.
The seat cover should not be replaced with any other than the one recommended by the manufacturer,
because the cover constitutes an integral part of the restraint performance.
The cover can be removed and washed by hand with a mild detergent or in a washing machine's cycle for
delicate items (30°C. The colours of the cover may fade if washed at more than 30°C. Do not spin, and never
tumble dry in an electric clothes dryer (the fabric may separate from the padding).
The plastic parts can be cleaned using soapy water. Do not use harsh cleaning agents (such as solvents).
The harness can be removed and washed in lukewarm soapy water.
Please refer to the cleaning instructions on the fabric label, which illustrates the following washing symbols:
Wash cold water 30°C
Do not tumble dry
Do not iron
Do not bleach
Dry Flat
Specifications and designs are based on the last information available at the time of printing and subject to change
without notice.
13