Neogen AccuPoint Advanced Next Gen Manual De Instrucciones página 3

Water Sample
01.
Turn the instrument on. Make sure it's at the
main screen.
02.
Select the correct site to be tested. A water
droplet icon on the display indicates to use a
water sampler.
03.
Take your sample
by dipping the water
sampler into the liquid.
04.
vertically and fully
depress to activate.
Note: The sampler must
be held vertically
05.
Mix for two seconds.
06.
instrument immediately
Hold the sampler
Place in
Access Sample
01.
Turn the instrument on. Make sure it's at the main screen.
02.
Select the correct site to be tested.
03.
Remove the Access sampler
and take your sample.
05.
Mix for two seconds.
04.
Hold the sampler
vertically and fully
depress to activate.
Note: The sampler must be
held vertically
06.
Place in
instrument immediately