Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4 - Slide a tubular dow-
el (D) through the sewn hem
at each end of the hammock
(F). Insert the dowel through
the loop rings (H) in the cutout
portions of the hammock. The
loop and ring should be on the
same side as the header bar.
Step 7 - Attach tubular dowel
(D) and loop ring to the insert-
ed V hooks.
MAINTENANCE:
1.
For best results and longer life, store your stand out of the weather to reduce possible rust problems.
Prolonged exposure to weather conditions including snow, rain, and humidity are not covered under
the warranty, nor is damage caused by normal wear, mildew, improper care including storage, mainte-
nance, and installation.
2.
BEFORE EACH USE, INSPECT ALL MOUNTING HARDWARE, STAND PARTS, POINTS OF CONNECTION AND
YOUR HAMMOCK FOR INDICATIONS OF WEAR OR DEFECTS PRIOR TO EVERY USE.
3.
Should the painted surface become scratched or chipped, obtain a matching paint and touch up spots
where the underlying metal is exposed to inhibit rust.
DO NOT EXCEED THE SUGGESTED WEIGHT LIMIT FOR YOUR HAMMOCK COMBO
WARRANTY INFORMATION: Texsport guarantees this product to be free of defects in workmanship and
materials for up to one year after the purchase date. If an item is found to be defective within one year of
its purchase, it will be replaced without charge upon the return of the unit accompanied by a sales receipt. If
you choose to return an item you must contact our customer service department at 800-231-1402 for further
instructions. Manufacturer not responsible for rot or decay caused by natural elements and wet climate con-
ditions. It is suggested that the stand and or hammock be removed from the elements when not in use.
Questions: If you should have any questions, problems or comments, please call our Customer Service De-
partment at 1-800-231-1402 or e-mail info@texsport.com. This Department is open M–F from 8 a.m.–5 p.m.
CST.
Step 5 - Place the straight side
of the spiral/V hooks (G) into
the two outer holes of header
bar (B). The curved portion
of the spiral/V hook should
point toward the hammock.
Attached the chain to the V
hooks.
Step 8 - Tie the pillow (E) to
the header bar (B).
Step 6 - Repeat step 4 and 5
for the other side of the ham-
mock bed (F), but without the
chain (H).
Step 9 - Your new hammock is
ready to enjoy.
Publicidad
