Charcoal Filter - GE JVM3162 Manual Del Propietário

About the exhaust feature.

Charcoal Filter

The charcoal filter cannot be cleaned. It must
be replaced. Order Part No. WB02X10943 from
your GE supplier.
If the model is not vented to the outside, the
air will be recirculated through a disposable
charcoal filter that helps remove smoke and
odors.
To Remove the Charcoal Filter
To remove the charcoal filter, first disconnect
power at the main fuse or circuit breaker, or pull
the plug.
To remove the top grille:
• open the microwave door
• remove 2 screws from the top
• slide the grille to the left and forward to
remove
You may need to open the cabinet doors to
remove the screws.
To Install the Charcoal Filter
To install a new charcoal filter, remove plastic
and other outer wrapping from the new filter.
Insert the top of the filter up and into the
grooves on the inside of the top opening. Push
the bottom of the filter in until it rests in place.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to
12 months, depending on usage). See Optional
Kits, page 8, for more information.
Slide the filter down and out.
Replace the grille by aligning the tabs with the
cutouts on the frame and sliding the grille to the
right. Replace the grille screws.
GEAppliances.com
19