Dirt Sensor - Sears Kenmore 116.32920 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DIRT SENSOR
The electronic
dirt sensor is a feature which
will detect particles
as they pass through the
vacuum cleaner.
The dirt sensor indicators and sensor
sensitivity switch are located on the front of
the switch cover,,
A red light
indicates dirt is
being picked up by
the cleaner., A
green light
indicates most
of the dirt has
been picked up
by the cleaner.
DM
Sensor
OPERATION
As you vacuum, the red indicator light will
come on and stay on as long as the sensor
detects a high concentration
of particles
passing through the cleaner.,
The green light indicates that most of the
cleaning is complete.
The sensor switch allows you to select the
sensitivity of the dirt sensor,, The switch can
be set to HI (+) or LO (-) sensitivity.
Set the sensor switch to the HI (+) position when:
. Cleaning bare floors.
• Cleaning carpet with low pile height.
Set the sensor switch to the LO (-) position when:
• Cleaning heavily soiled areas,
• Cleaning carpet with deep pile,.
• Cleaning new carpets_
Even with the
sensor switch in
the LO (-)
position, the dirt
sensor will detect
carpet fuzz,
especially
on new
carpet, which
may cause the
red light to remain
on longer than
expected,,
Sensor
Sensitivity i
Switch._/
WARNING
Electrical Shock
And Personal
injury
Hazard
Disconnect
electrical
supply
before
servicing
or cleaning the unit. Failure
to do so could
result
in electrical
shock
or personal
injury
from cleaner
suddenly
starting,
TO CLEAN DIRT SENSOR OPTICS
The dirt sensor optics consist of two optic
cells located inside the valve assembly°
Occasionally,
it may become necessary to
clean the two optic cells to assure maximum
performance.
Clean optic sensors:
• When the red light stays on continuously.
• When the green light stays on
continuously.
• When dirt or dust adheres to the optic cells,,
• Whenever the dust cup is cleaned.
Valve
Assembly
To clean the sensor, remove deep cleaning
nozzle hose at valve assembly by lifting
hose straight uF Remove extension
hose
from the valve assembly
by grasping hose
collar, twisting, and pulling straight off.
Lay cleaner back by pressing the handle
release pedal (see Releasing the Handle
page 8).
With the hoses
removed you can
insert a cloth into
the valve opening.
Wipe the optic
sensors with a soft,
dry cloth.
_e
_
Opening
'_"" Va lve
Never use cleaners or liquids as they can
help speed the recoating of the optic cells
and make it necessary
to clean them much
sooner than normal.
Return cleaner to the upright position, Re-
14 attach nozzle hose and extension
hose,

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 116.32921

Tabla de contenido