Horizon Global 76471 Instrucciones De Instalación página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Install Hitch - Raise hitch and bumper beam into position and align holes with studs in end panel. See Figure 1. Raise the exhaust hanger bracket back into position,
and loosely reinstall the (4) existing M10 bolts and (4) M10 flange nuts into end panel. Tighten all M10-1.50 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M)
Existing M10 Nuts
(4) Places
Existing M10 Bolts
(4) Places
5. Trim fascia –Locate the center of the fascia. Using a tape measure, marker, and utility knife, cut a notch in the bottom of fascia approximately 4.25'' wide by 3.5" tall.
See Figure 3. Note: Be sure area is clear of all electrical wiring before trimming.
Area to trim
©2021 Horizon Global™ Corp - Printed in Mexico
Proper torque is needed to keep the hitch secure to the vehicle
End panel
when towing.
Figure 1
Exhaust Hanger Bracket
C
L
4.25"
3.50"
Figure 3
Bumper beam
Sheet 7 of 24
76471NP
5-6-21
Rev. A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

84471Cqt76471

Tabla de contenido