Functional Description; Electrical Connection; Extension Cable - MIRKA Miro 955 Instrucciones De Manejo

4. Maintain proper footing and balance at all times. Do not overreach. Use proper scaffolding
5. Always wear appropriate safety equipment when operating.
6. Important: After completing sanding, switch off the switch and wait for the coasting
sanding head to stop completely before putting the tool down.
7. Never operate the tool in an area with flammable solids, liquids, or gases. Sparks from the
commutator/carbon brushes could cause a fire or explosion.
8. There are cer tain applications for which this tool was designed. The manufacturer
strongly recommends that this tool NOT be modified and/or used for any application other
than for which it was designed. If you have any questions relative to its application DO NOT
use the tool until you have written the manufacturer and have been advised.
9. Use the machine with both hands at all times. Loss of control can cause personal injury.
10. Keep power supply cord clear from the working range of the machine. Always lead the
cable away behind you.
11. Immediately switch off the machine if unusual vibrations or if other malfunctions occur.
Check the machine in order to find out the cause.
12. The dust that arises when working with this tool can be harmful to health. Use a dust
absorption system and wear a suitable dust protection mask and remove deposited dust with
a vacuum cleaner.

FUNCTIONAL DESCRIPTION

This Electric Drywall Sander is specially designed for the most efficient sanding of drywall or
plaster walls and ceilings for both new construction and renovation work. It is designed to work
in conjunction with a vacuum cleaner for minimum dust and best sanding results. The pivoting
sanding head allows excellent results with minimum time and effort.

Electrical connection

The network voltage must conform to the voltage indicated on the tool name plate. Under no
circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to
repair the damaged cable yourself. The use of damaged power cables can lead to an electric shock.

Extension cable

If an extension cable is required, it must have a sufficient cross-section so as to prevent an
excessive drop in voltage or overheating. An excessive drop in voltage reduces the output and can
lead to failure of the motor. The following table showsyou the correct cable diameter as a function
of the cable length for this machine. Use only U.L. and CSA listed extension cables. Never use two
extension cables together. Instead, use a long one.
5
79