HURAKAN HKN-VRX1200/330 Manual Del Usuario página 16

EN
Safety Tips
⚫ Position on a flat, stable surface.
⚫ A service agent/qualified technician should carry out installation and any repairs if
required. Do not remove any components or service panels on this product. Consult Local and
National Standards to comply with the following:
· Health and Safety at Work Legislation
· BS EN Codes of Practice
· Fire Precautions
· IEE Wiring Regulations
· Building Regulations
⚫ DO NOT use jet/pressure washers to clean the appliance.
⚫ DO NOT use the appliance outside.
⚫ DO NOT use this appliance to store medical supplies.
⚫ DO NOT use electrical appliances inside the appliance. (e.g.heaters, ice-cream makers
etc.)
⚫ Always carry, store and handle the appliance in a vertical position and move by holding
the base of the appliance.
⚫ Always switch off and disconnect the power supply to the unit before cleaning.
⚫ Keep all packing away from children. Dispose of the packaging in accordance with the
regulations of local authorities.
⚫ If the power cord is damaged, it must be replaced by an agent or a recommended
qualified technician in order to avoid a hazard.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and
operation of this machine will provide the best possible performance from your product.
We pride ourselves on quality and service, ensuring that at the time of packing the contents
are supplied fully functional and free of damage. Should you find any damage as a result of
transit, please contact your dealer immediately.
Installation
Note: If the unit has not been stored or move in an upright position, let it stand upright for
approximately 12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging. Make sure that all protective plastic film and
coatings are thoroughly removed from all surfaces.
2. Maintain a distance of 20 cm (7 inches) between the unit and walls or other objects for
ventilation increase this distance if the obstacle is a heat source.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the appliance in position OR level the appliance by
adjusting the screw feet.
Installing glass panels (optional)
1. Screw the couplings onto the edge of the product.
Note: make sure that the hole of the coupling for the goujon faces inward.
16