Publicidad
Idiomas disponibles
Idiomas disponibles
2. Insert two side panels into the couplings so that the holes in the glass will be on top.
Note: make sure the threaded hole that is the farthest from the side of the panel faces the
back of the product.
3. Screw in a goujon into each coupling to fix the panels in place.
Note: make sure the soft tip of the goujon is pressed against the glass.
4. Insert the back panel into the couplings so that the holes in the glass are on top.
5. Screw a goujon into each coupling to fix the panel in place.
6. Insert the plastic stoppers into each hole.
7. Screw on the brackets on the inside of each panel using the bolt assemblies.
Note: make sure the shorter end of the bolt assembly is on the outside of the panels.
8. Put the top panel onto the brackets so that all the holes match up.
9. Insert stoppers and attach the top panel to the brackets using the bolt assemblies.
Operation
Storing Food
To get the best result from your appliance, follow these instructions:
· Only store foodstuffs in the appliance when it has reached the correct operating
temperature.
· Do not place uncovered hot food or liquid inside the appliance.
· Warp or cover food where possible.
· Do not obstruct the fans inside the appliance.
Turn on
1. Close the door(s) of the appliance.
2. Ensure the power switch is set to [O] and turn on at the socket.
3. Switch on the power [l]. The current temperature within the appliance is displayed.
Cleaning, Care & Maintenance
· Switch off and disconnect from the power supply before cleaning.
· Clean the interior of the appliance as often as possible.
· Do not use abrasive cleaning agents. These can leave harmful residues.
· Clean the door seal with water only.
· Always wipe dry after cleaning.
· Take care when cleaning the rear of the appliance. Sharp edges can cut.
An agent or qualified technician must carry out repairs if required.
Brackets
Glass panel
Bolt
assembly
Stopper
Bolt assembly
EN
17
Publicidad
