Tabla de contenido
Publicidad
1
1
T. INFO
20
All manuals and user guides at all-guides.com
I N T L Z
PWR
NFP ON
NFP OFF
Basic Operation
Turning Power
On and Off
Press the PWR button to turn on the unit.
Note: The unit can be turned on by pressing
any other button except the eject c
button.
The volume level gradually increases to the
previous level you were listening to before the
unit was turned off. Press the PWR button
again to turn off the unit.
Non Fader Pre-out
(N.F.P.) On and Off
Use the N.F.P. On mode when a non-fading
signal would be most effective. For example, to
drive an amplifier with a low-pass filter for the
subwoofer.
Press and hold the T. INFO button for at least 3
seconds.
With each press, N.F.P. is toggled On or Off.
N.F.P. ON: In this position, the Front Pre-
Output on the TDA-7567R or Rear
Output on the TDR-7565R will not
be affected by the fader. This is
ideal for driving a subwoofer
amplifier.
N.F.P. OFF: Returns to normal fader mode.
Notes:
• Initial mode is "NFP OFF."
• Set the N.F.P. to OFF unless the subwoofer is
used.
• If an optional Processor with subwoofer
output is connected via the Ai-NET bus, this
button will turn that output ON or OFF.
English
Publicidad
Tabla de contenido
