Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Locate remote control. Start with the
lights OFF and test the light ON/OFF function and
the dimmer funcion with the
speed with different fan speed buttons (I - VI). If the
remote control operates all of the functions of the
fan, battery has been installed correctly. If the
remote controls does not operate all of the fan
functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan in
reverse. Use
button to recirculate air depending
on the season. A ceiling fan will allow you to raise
your thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
NOTE: If the remote control interferes with other
appliances, change code switches on the remote
control to another code. If you do change the code,
turn power off first. After setting the new code on
the remote control, go back to the instructions for
SET button in Section 10 (page 9).
IMPORTANT: Remote control must be synchronized
with fan in order to properly function.
All manuals and user guides at all-guides.com
button. Test fan
page 10
Remote Control
II
Modifications not approved by the party responsible for compliance could void
the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
*
Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and receiver.
*
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IV
III
V
I
VI
Publicidad
Capítulos
Tabla de contenido
