Troubleshooting - LOCO COOKERS LCSQHPFS El Manual Del Propietario

5. To clean the burner tube/venturi, first
disconnect the regulator hose from the
burner tube. Look inside the burner
tube for nests, webs or mud. To remove
obstructions, use a flexible brush or bend
a small hook on the end of a flexible wire.
When obstructions are clear the regulator
hose can be connected to the burner tube.
PROBLEM
Burner will not light.
Burner does not stay lit.
Water, grease or oil does
not reach desired cooking
temperature.
lococookers.com
CARE AND MAINTENANCE

TROUBLESHOOTING

POSSIBLE CAUSE
Bad connection between the
regulator and LP tank.
The LP tank is empty.
Excessive wind conditions.
The LP tank is empty.
Regulator control knob is not
fully opened.
Overfill Protection Device (OPD)
on LP tank has been activated/
tripped.
Faulty or obstructed regulator
hose.
6. Confirm that all components are completely
dry before using or placing in storage.
7. It is recommended to thoroughly clean the
appliance prior to every use.
8. Store all components in a clean, dry location
when not in use.
SOLUTION
Make sure the regulator
coupling nut is fully tightened on
the LP tank valve.
Refill LP tank at an authorized
dealer or purchase new filled LP
tank.
When appliance is cool, move
appliance to different location
where high wind is not a factor.
Relight burner.
Refill LP tank at an authorized
dealer or purchase new filled LP
tank.
Fully open regulator control
knob by rotating it in a clockwise
direction.
To reset the Overfill Protection
Device, turn the regulator
control knob and the LP tank
valve OFF. Disconnect the
regulator from the LP tank
and wait at least one minute.
Reconnect the regulator to the
LP tank and fully open LP tank
valve.
Contact customer service for
replacement regulator/hose
assembly.
14